EuroLite CLS-41 Manual Del Usuario página 17

carbines must be sufficiently dimensioned and used correctly in accordance with the latest industrial safety
regulations (e. g. BGV C1, BGI 810-3).
Please note: for overhead rigging in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Pull the safety bond through the attachment eyelet and over the trussing system or a safe fixation spot.
Insert the end in the quick link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already held the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!
OPERATION
After you switch on the power switch, the CLS-41 start running. The lamps light up with the dichroic colors
red, yellow, blue and green.
You can do without a controller as the CLS-41 features a built-in microphone, which provides automatic
sound control. You can adjust the sensitivity of the microphone, the tempo of the chaser and additionally the
three modi with the rotary-controls or the selector switch respectively on the rearpanel.
Master/Slave-Operation
The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the CLS-41 you can find a 9-pole Sub-D socket (OUT) and a 9-pole Sub-D plug (IN),
which can be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via the link cable. Connect the OUT-
socket with the IN-plug of the next device.
Choose the slave device by adjusting the selector switch on the rear panel.
Foot-Controller Operation
If you have connected the footswitch to the socket, you can lock the light output and turn it on again.
Buttons 1 – 3 from left to right:
Button 1: Turns the lamp on again and/or begins the next step with the chaser on channel 1.
Button 2: Same function as button 1.
Button 3: Turns the lamps off
DANGER TO LIFE!
17/35 00026000.DOC, Version 1.3