Wesco WS2001 Manual Original página 6

VIBRATION INFORMATION
Vibration total values (triax vector sum) determined according to EN 62841:
Vibration information value
The declared vibration total value and the declared noise emission value have been measured in accordance with a standard test method and
may be used for comparing one tool with another.
The declared vibration total value and the declared noise emission value may also be used in a preliminary assessment of exposure.
WARNING: The vibration and noise emissions during actual use of the power tool can differ from the declared value depending on
the ways in which the tool is used especially what kind of workpiece is processed dependant on the following examples and other
variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti vibration and noise accessories are used.
And the tool is being used as intended by its design and these instructions.
This tool may cause hand-arm vibration syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of exposure level in the actual conditions of use should also take account of all parts of the
operating cycle such as the times when the tool is switched off and when it is running idle but not actually doing the job. This may
significantly reduce the exposure level over the total working period.
Helping to minimise your vibration and noise exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti vibration and noise accessories.
Plan your work schedule to spread any high vibration tool use across a number of days.
ACCESSORIES
60mm magnetic bit holder
50mm PH2 impact bit
USB Cable(Type C)
25mm screwdriver bit with color ring
(H5*1/H4*2/H3*2/T20*2/T15*2/T10*1/S0*1/S1*1/S2*1/
SL3*1/SL4*1/SL5*1/PZ1*1/PZ2*1/PH1*2/PH2*3/PH3*1)
We recommend that you purchase your accessories from the same store that sold you the tool. Refer to the accessory packaging for further
details. Store personnel can assist you and offer advice.
6
a =0,372 m/s
2
h
Uncertainty K = 1,5 m/s²
1
1
1
24
EN