Reiner P1-MP Manual De Instrucciones página 10

1. Making the print head ready for use
1.1. Opening the pack  Fig.
The aluminium pouch has a resealable zip fastening
With scissors, cut open the top of the pack between
f
the weld seam
Unzip the pack.
f
2
Take out the print head
f
1.2. Releasing the clip  Fig.
The print head
Place the print head
f
of about 45° as shown in figure
Hold the red clip
f
With the other hand, press the print head
f
clip arms
5
away from the clip
2. Printing material
For the best results, use material that is clean, non-greasy, dry
and at the same temperature as the print head.
Before carrying out a large print job, perform a test print.
9
and the zip fastening
1
.
4
is supplied with a reusable clip
4
on a firm surface at an angle
4
by the point with one hand.
3
will spring out and the print head
.
3
A
.
2
B
C
+
C
.
4
.
2
.
3
down firmly. The
will slide
4