Publicidad
Idiomas disponibles
Idiomas disponibles
EN
3.Special safety instructions for battery tool
1) Make sure the battery switch is OFF before inserting the power line of the tying machine into the battery. Inserting the battery
if the switch is ON may cause damage to the device.
2) As the charger is only for indoor usage, the battery shall be charged in a dry and ventilated place indoor. No objects are allowed
to cover on charger and battery, so as to ensure the sufficient heat dissipation of charger and battery.
3) Before cleaning the charger, turn it off to reduce the risk of charging.
4) Do not put the battery under strong light for a long time. Do not place the battery on hot surface. Heat will damage the battery
and may cause explosion.
5) Please ensure that the high-temperature battery is fully cooled before charging.
6) Do not take apart the battery, to avoid any mechanical damage to the battery. May cause a short circuit, or exudes harmful
gases to the respiratory tract. if have any discomfort, please inhale fresh air and seek medical attention in time.
7) Do not use non-rechargeable batteries.
4.The correct use of the charger
1) The battery can only be charged by the provided charger. Otherwise, it may cause a fire or explosion. Use the original charger
to ensure the safety of the equipment.
2) Always check the charger, wire and plug before every use. If damaged, please contact qualified professional personnel for
repair, and only use the original components. Do not use defective charger, and do not take apart it by yourself to ensure the
safety of the equipment.
3) The charger's socket must be grounded. Make sure that the supply voltage matches the rated voltage of the nameplate on the
charger. Otherwise, may cause electric shock.
4) Disconnect the charger from the power supply before switching on or off the connection among the battery / power tool / device.
5) Keep the charger clean and away from the damp environment and rain. Do not use the charger outdoors. The entry of dirt or
water will increase the risk of electric shock.
6) The charger can only be used to charge the original battery, otherwise, may result in personal injury and cause a fire.
7) Avoid any mechanical damage to the charger. Otherwise, may cause internal short circuit.
8) Do not use chargers on flammable surfaces (e.g. paper, textiles).
9) If the wire of the equipment is damaged, it must be replaced by the manufacturer, customer service personnel or the personnel
with the same or similar qualification, to prevent potential danger.
5.Other risks
Even if the power tool is used properly, some risks will still exist. The power tool may bring the following hidden dangers due to
its own structure and structural characteristics:
1) Sharp damage
2) Noise will damage your hearing if without any ear protection.
3) Long time or unreasonable manual operation of the tool may cause damage to the user's body.
8
Publicidad
