Publicidad
Idiomas disponibles
Idiomas disponibles
EN
11
Turn on the power and test run. Use pliers to
remove the test tying wire
Before starting overhaul, please switch off the equipment. Disconnect the connection between battery and the
equipment, and place battery in a safe package.
Cleaning and maintenance
1. Don't spray water on the equipment or immerse it in water, otherwise the equipment will be damaged.
2. It shall be cleaned with a wet cloth or a brush. Don't use any cleaning agent; otherwise it may cause permanent damage to
the equipment.
3. Each time after one roll of tying wire is used up, please use pliers or a brush to clear up foreign matters on the guideway and
twisting wheel.
4. After prolonged use, check if the pin, retaining ring and spring of each moving joint have any foreign particles. If yes, eliminate
them on time. Periodically add lubricating oil to the cutter and to each joint. A good maintenance habit can prolong the life of
the product effectively.
Open pressing plate
Install the back cover and... complete!
2 8
Use a brush to clean the guideway
14
Publicidad
