Safety instructions
ATTENTION! Follow the safety instructions and assembly instructions to avoid the risk of
injury or damage to the product.
Only suitable for domestic use and not for commercial use!
Keep small parts out of the reach of children. Also make sure to keep plastic bags and
other packaging material away from children, especially when unpacking! Danger of
suffocation!
Check the scope of delivery for completeness. Later complaints cannot be accepted.
Check all elements and parts for damage. Despite careful checks, it can happen that
even the best goods are damaged during transport. In such a case, do not assemble
your product. Defective parts can cause danger and damage to health.
Never make any changes to the product! Modifications will invalidate the warranty
and the product may become unsafe or, in the worst case, even dangerous.
Use a sponge and warm soapy water for cleaning. Do not use cleaners or detergents
containing solvents, e.g. bleach can damage the product.
Application:
Electronic pressure switch for controlling pumps for rainwater harvesting, water supply and sprinkling in
domestic systems. For clear to slightly polluted water without aggressive components.
Attention
Do not remove the circuit board from the housing under any circumstances.
The circuit diagram is located on the inside of the cover. It shows you the correct
connection. An incorrect connection can destroy the entire electronic circuit.
Use a three-core connection cable (min. 3G0.75 mm²) with forced earthing end. The
cables used should have an outer diameter between 7.5 mm and 8.5 mm. The current-
carrying cables must be lower than the fastening nut at one point, as shown in the
illustration.
The four screws on the cover and the two nuts for fixing the cables must be tightened
firmly to prevent water from entering the interior of this unit and damaging the
electronic circuit.
Hergestellt für Dilaw Warehouse GmbH // Fuggerstraße 15a // 48165 Münster // Germany
8
www.eshopping.de