Philips AUT2016 Manual Del Usuario página 13

d. Reset button
To reset the filter lifetime, long press the reset button of the filter that needs to
be replaced for 5 seconds. You will hear a beep, and the lifetime indicator of the
specific filter flashes blue for twice, and turns constant blue light. This means
the filter lifetime has been reset successfully.
VI. Maintenance
1. Routine maintenance
- Organic solvent such as gasoline etc. shall not be used for wiping the housing
of the device. If cleaning is required, please gently wipe the surface of the product
with a wet cloth after it is disconnected from the power supply.
- If the system is not used for more than 2 days, turn on the faucet and allow the
water to run for at least 5 minutes to flush the filters and the system.
- If the system will not be used for an extended period, take out the lter cartridges,
seal them with plastic wraps, and store them in the refrigerator (not in the freezer).
Turn off the three-way ball valve, turn on the faucet to empty the system, and
turn o the power. Before using it again, allow the water to run for at least 10 minutes
to flush the filters and the system.
2. Filter lifetime
Note
For the best performance, please change your filter cartridge according to the
filter lifetime indicator, or the filter replacement cycle suggested below. When a
signi cantly lower ow rate is observed, we recommend changing the lters as well.
This system can only work with Philips filters.
System model code
Filter, model code, and filter lifetime
CP filter, AUT706, 6-12 months*
RO filter, AUT747, 24-36 months*
11
AUT2016