Publicidad
Idiomas disponibles
Idiomas disponibles
Installation instruction
•
Make sure the temperature of the places where the washer is installed or placed above
0°C or put it outside.
•
Place the washer correctly according to management standards and regulations.
•
Keep the base of washer ventilated when it is placed on the ground with carpet.
•
There are too much pests in villages. Please keep the surroundings clean because any
damages caused by cockroaches or other pests don't belong to warranty.
Transportation bolt
Washers are installed with transport bolt to prevent internal damage in transit.
Dismantle the transportation bolt
9. In order to prevent internal damage in transit, 4 bolts are installed. Before using the
washer, dismantle the bolt. (see chart 1)
• If the bolts are not dismantled, violent vibration, noise and trouble will be caused.
10. Use the attached wrench to loosen the 4 bolts. (see chart 2)
11. Twist the bolt rubber slightly and then pull out the bolts, keep the bolts and wrench as
standby. (see chart 3)
• The bolts should be remounted no matter when to transport the washer.
12. Use attached stopples to seal the screw holes. (see chart 4)
Notice:
Please don't
dismantle the
drainpipe fixed
device.
63
Publicidad
