Publicidad
Idiomas disponibles
Idiomas disponibles
•
Once your washer smokes or emits an odor, please cur the power and contact with
professional maintenance staff.
Washers should be connected with water inlet. Please use attached new plumbing rather
than the old.
In order to ensure the quality, water injection tests are carried out before the washer leaves
factory, so there may be water inside the internal tub, door seals and door panel, which are
normal.
Water inlet connection
7. The pressure of supply water should be between 30kPa
and 1000kPa.
8. Don't abrade the screw thread when connect the inlet
pipes with valves.
9. Please install dropping equipment if the pressure of supply
water surpasses 1000kPa.
Two seals are supplied in the connectors of both ends of
the pipe to prevent water leaking.
•
Turn on the tap and check if the connectors leak.
•
Check the pipes regularly. Please change them if
necessary.
•
Make sure the pipes don't be damaged or twine with
each other.
The connection of inlet pipes and taps
1
Check the rubber seals on both sides
of the hose. Insert a rubber seal into
the threaded fittings on each hose to
prevent leaking.
Rubber seal
Water hose
(To water inlet on the
washing machine)
3
After connecting inlet hose to water
faucets, turn on the water faucets to
flush out foreign substances (dirt,
sand or sawdust) in the water lines.
Let water drain into a bucket, and
check the water temperature.
Use the standard faucet
standard faucet
longer faucet
square faucet
2
Connect the water supply hoses to the
water faucets tightly by hand and then
tighten another 2/3 turn with pliers.
-Connect the blue hose to water faucet.
WARNING
• Do not overtighten. Damage to the coupling can result.
4
Connect the hoses to the water inlet tightly
by hand and then tighten another 2/3 turn
with pliers.
65
Publicidad
