Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING – The distance
between the machine and
15m (50ft)
bystanders shall be at least
15 m (50 ft)
WARNING – Beware of thrown
objects
WARNING – Beware of blade
thrust
WARNING – Disconnect battery
before maintenance
Wear hand protection
Li-Ion battery, battery must be
recycled
Do not burn
Batteries may enter water
cycle if disposed improperly,
which can be hazardous for
ecosystem. Do not dispose of
waste batteries as unsorted
municipal waste.
Make sure the battery is
removed prior to changing
accessories.
Trimming
POSITEC Inc. has established a partnership with
the RBRC Corporation to recycle any Positec
batteries with the RBRC-call2recycle seal. For
environmental protection, please do not discard
batteries in the trash. After the batteries' life cycle
is ended, then please call 1-800-822-8837 for
a free service that will properly dispose of the
battery.
ASSEMBLY & OPERATION
NOTE: Before using the tool, read the
instruction book carefully.
BEFORE OPERATION:
Assembling the cutting head (See Fig. A1)
1. Fit the cutting head. Insert the torx key
into the hole and rotate the trimmer head
counterclockwise until it stops in a locked
position.
A1
Assembling the debris guard (See Fig. A2)
A2
1. Install the correct Debris Guard for the trimmer
head.
2. Secure the guard in place using the screw and
torx key.
Assembling the Front Handle (See Fig. B)
1. Attach the Front Handle and lower clamp on the
shaft.
2. Put the bolt through the holes.
3. Tighten the Front Handle.
WARNING: Adjust the Front Handle as
desired so as to make sure your front
arm is straight when using the trimmer.
EN
9
Publicidad
