Publicidad
Idiomas disponibles
Idiomas disponibles
EN
• After the rear part finish, make the front part of the armrest close to the metal tube, and insert the
hook on the armrest front part to the seat frame metal tube. (Figure 7)
• Press the armrest downward until it in the right position, then push the front part of the armrest
upward, make the hook which on the armrest front part close to the metal tube, swing the armrest
gently, check the armrest is it installed well. (Figure 8)
• Unzip the PU cover on the upper arm, across the cross screw from the capsule screw hole with a
cross screw driver, and make the capsule and armrest fixed well, then zip up the upper arm PU cover.
(Figure 9)
• Align the hole on the metal tube which on the front part of the armrest, tighten the cross screw on
the armrest frame with a cross screw driver, finish the installation, and the same steps for the two
armrests. (Figure 10)
E. Calf installation
• Install the rotating shaft in calf fixed axis first, noticed the hole should be aligned, so that the R shape
pin assembly (Figure 1)
• After calf is connected with the fixed axis aligned, then insert (Figure 2)
Method of usage
Figure 7
Figure 9
Figure 1
28
Figure 8
Figure 10
Figure 2
Publicidad
