Publicidad
Idiomas disponibles
Idiomas disponibles
B
Product usage
Press again to switch to Water absorb mode
2.
Press again to switch to Eletrolysis water mode
3.
NOTE:
•
Press
, Water absorb
Standard mode is the default mode.
•
Power mode is ideal for cleaning tougher dirts and stains.
•
Water absorb mode is ideal for absorbing excess water on the floor while
•
cleaning.
Eletrolysis water mode is for cleaning with eletrolyzed water for disinfection.
•
CAUTION: Do not use the Floorwasher to clean surface with foam liquid. It is
recommended using Power mode for tougher dirts and stains.
•
The LED of the currently selected mode will light up on the display panel.
Clean the dirty water cup
NOTE:
•
After using the Floorwasher, check the suction nozzle regularly and clean the
dirty water cup timely to keep the air tunnel unblocked so as to prevent from
any blockages that might cause suction dropping and motor overheating, thus
affecting the performance and service life of the product.
•
Clean the dirty water cup after each cleaning, or when the dirty water exceeds
the water line on the dirty water cup
Press the dirty water cup release button, and then pull out the cup.
While holding the cup, press the dirty water cup release button and pull the cover
with the dirt separator upward to remove it from the cup.
Empty the cup, and then place the cup back to the main body. Push the cup in until
it clicks into place.
on the handle will toggle among Standard mode
mode and Eletrolysis water mode
11
.
.
EN
, Power mode
.
Publicidad
