VALBERG FL5 Instrucciones De Uso página 16

C
Cleaning and maintenance
Clean the rolling brush cover
Use your thumb and forefinger together and press the release locks inward, and then
pull upward to detach the cover.
Clean the rolling brush cover with the cleaning brush provided under running tap water.
After cleaning, allow the cover to dry
Clean the rolling brush
Tips:
• If there are residual stains on the suction nozzle, please
wipe it clean with a damp cloth. Do not rinse with water.
Pull the rolling brush release lock handle on the left side.
Hold the rolling brush release lock handle and pull the rolling brush leftward to
detach it from the spindle on the right side.
Wipe clean the rolling brush compartment with a damp cloth.
Use the hook end of the supplied cleaning brush to remove any tangled hair or debris
from the rolling brush. Then, rinse the rolling brush under tap water.
Attach the rolling brush back to the Floorwasher.
a. Insert the right side of the rolling brush into the spindle at the right end.
b. Put the left side of the rolling brush into the left end and align with the slot.
c. Push the rolling brush release lock handle in until it clicks into place.
Attach the rolling bush cover back to the Floorwasher.
• Use your thumb and forefinger together and press the release locks inward, and
then push down the cover until both sides click into place.
15 EN