Publicidad
Idiomas disponibles
Idiomas disponibles
Operation (continued)
EMPTY BUCKET LIGHT
If this light is on, the fan and the compressor will stop running. This light indicates that you need to check:
□ If the bucket is full, empty and re-install bucket. If the bucket is not in position, remove the bucket and re-install it.
Make sure the bucket fits all the way into the dehumidifier and the bucket light is off, or dehumidifier will not run.
FAN SPEED
HIGH
/ÉL
□ This model has only one Fan speed.
LOW
/FAIBLE
HUMIDITY LEVEL
□ Press the Plus or Minus button to set the desired humidity level. Desired humidity in the digital display will flash for 5
HIGH
/ÉLEVÉ
seconds after operation.
□ Actual room humidity will be displayed after 5 seconds of flashing the desired humidity.
□ To set the dehumidifier for continuous operation, press the Minus button until "CO" flash for 5 seconds and then
display. In continuous mode, room humidity will NOT be display.
□ When the dehumidifier is operating in continuous mode, press Plus button and then unit will stop the
continuous running and go back to manual mode.
LOW
/FAIBLE
DIGITAL DISPLAY
Display shows relative humidity.
□ When the dehumidifier operates in Manual Set mode, the display shows the relative humidity of the room.
□
"CO" will be displayed when the dehumidifier is operating in continuous mode.
□ In continuous mode, room humidity will NOT display.
CLEAN FILTER
□ When the Clean Filter indicator light is on,remove, clean and replace the air filter. See "Cleaning the Air Filter".
[ 5 sec ] reset filter
□ Press the POWER button for 5 seconds after cleaning and replacing the air filter to reset the filter monitor.
POWER
2
Normal Sounds
When your dehumidifier is operating normally, you may hear sounds such as:
□ Air movement from the fan.
□ Clicks from the thermostat cycling.
□ A high-pitched hum or pulsating noise caused by the high-efficiency compressor cycling on and off.
NOTE: Once the relative humidity of the room hits the desired setting, the compressor will stop and
the fan will be off periodically. The fan may periodically turn on, to read the humidity level, without the
compressor running.
FAN
FAN
FAN
/VENT.
NOTE: Humidity can only be adjusted manually in Manual Set mode. In Continuous mode, humidity
level is set automatically.
NOTE: When the light is on, it will remain on for 180 hours or until you press POWER button for 5 seconds.
10
Publicidad
