Hisense DH2524K1W Instrucciones De Instalacion Y Uso página 9

Operation
□ Before turning on the dehumidifier, be sure that the bucket is empty and fits all
the way into the dehumidifier.
□ Each time you unplug the dehumidifier or power is interrupted, the controls will
return to the previous settings when power is restored.
□ Humidity displayed is between 30% and 90% relative humidity.
□ Humidity can be set between 30% and 80% relative humidity.
□ It's important to set the desired humidity level to an achievable setting. To ensure energy-efficient operation, only use the dehumidifier
in a closed space, with no open windows or other sources of moist air (to avoid continuous running).
□ Operating temperature is between 38°F to 90°F (3.2°C to 32.2°C). At temperatures of 38°F (3.2°C) or less, water freezes inside the
product. At temperatures over 90°F (32.2°C), the internal temperature of the product trips a protective device which deactivates the
product to avoid product damage.
□ The compressor has a 3-minute delay before restarting. If the product is stopped and immediately restarted, to protect the compressor
there is a 3-minute delay until the compressor restarts.
□ When the dehumidifier is operating, the indoor temperature will rise. The dehumidifier does not have a cooling/heating function. Heat is
generated during operation, so the room temperature may be increased by about 6°F (3°C) depending on the usage conditions (indoor
temperature, size of the room).
1
Using the Control Panel
COOL/FRAIS
POWER ON OR OFF
DRY/SEC
□ Press POWER to turn on or off the dehumidifier.
TIMER SLEEP
/MINUT. /VEILLE
FAN/VENT.
POWER MODE
/MARCHE
NOTE: In the case of a power outage or interruption, the dehumidifier will automatically restart at the last use setting
when the power is restored.
DESIRED HUMIDITY MODE
□ Humidity can be adjusted manually.
□ If the humidity level of the room is higher than the desired humidity setting, the compressor will turn on. If not, the
compressor will turn off, as well as the fan.
NOTE: The de-icing function will turn off the compressor if a low temperature condition occurs. When the de-icer senses
the correct operating temperature the compressor will cycle back on. Some freezing is normal when dehumidifiers are used
at low temperatures.
HIGH
/ÉLEVÉ
LOW
/FAIBLE
HIGH
/ÉLEVÉ
LOW
/VENT.
FAN
/FAIBLE
9
NOTE: In the event of a power failure, your
dehumidifier will operate at the previous
settings when the power is restored.
NOTE: The symbols may be
different from these models,
but the functions are similar.
NOTE: Set point is relative
humidity: lower is more dry,
higher is less dry.
FAN
/VENT.