Publicidad
Idiomas disponibles
Idiomas disponibles
Operation (continued)
DIGITAL DISPLAY
Display shows relative humidity or time (depending on setting).
□ When the dehumidifier operates in Manual Set mode, the display shows the relative humidity of the room.
□ When the timer is selected, the display shows the time when the dehumidifier will turn on or turn off, depending
on the setting.
TIMER
To set Timer for a 30-minute to 24-hour delay before the dehumidifier is turned off (the dehumidifier must be On):
□ Press TIMER. Timer indicator light will come on, and the display will flash. The display will show remaining
time before the dehumidifier wiII turn off.
□ Press the Plus or Minus button to change the delay time, from 30 minutes to 24 hours.
To set Timer to turn on the dehumidifier, with previous setting:
□ Turn off the dehumidifier.
□ Press TIMER. Timer indicator light will flash. The display will show remaining time before the dehumidifier will
turn on.
□ Press the Plus or Minus button to change the delay time, from 30 minutes to 24 hours.
To clear the Timer delay program:
□ Press TIMER once after it has been programmed. Display will show remaining time. While the display is showing
the remaining time, press TIMER again. Timer indicator light will turn off.
NOTE: Dehumidifier can be either on or off.
To see the remaining time:
□ Press TIMER once after it has been programmed. Display will show remaining time.
NOTE: Empty the water bucket before setting the timer function. If the water bucket becomes full
during the Timer function, the Empty Bucket light goes on and dehumidification stops.
CLEAN FILTER
□ When the Clean Filter indicator light is on,remove, clean and replace the air filter. See "Cleaning the Air Filter".
□ Press the Clean Filter button to reset the filter monitor.
NOTE: When the light is on, it will remain on for 180 hours or until you press Clean Filter button.
PUMP (for pump function model only)
This feature pumps water horizontally or vertically. Pump water to a drain, out a window or anywhere you think suitable.
IMPORTANT: You must connect the drain hose to the unit before pressing the Pump button, or the
pump will not operate. See "Pump drain" for connecting instructions.
□ Press PUMP to activate the pump system for active drainage.
□ Once the pump button is pressed, the pump light will switch on.
NOTE:
□ If the pump light flashes, it means that the pump is not functioning properly.
□ If the drain hose is not correctly connected to the unit or is bent, the pump light will flash and the
pump system will not work. See ''Trouble shooting" for direction.
11
Publicidad
