Ryobi PBLMT51 Manual Del Operador página 6

WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
„ Cutting wood, drywall, plastic
„ Detailed sanding
„ Using accessories identified as compatible with this
multi-tool
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 10.
„ Make sure the variable speed dial is in the OFF ( 0 )
position.
„ Insert the battery pack into the battery port as shown.
„ Make sure the latches on the battery pack snap into place
and the battery pack is secured in the product before
beginning operation.
„ Depress the latches to release and remove the battery
pack.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
WARNING:
Battery tools are always in operating condition. Place
the tool in the OFF position when not in use or carrying
at your side.
OPERATION
SWITCH TRIGGER
See Figure 2, page 10.
„ To turn the multi tool on: Depress the switch trigger.
„ To turn the multi tool off: Release the switch trigger.
LOCK-ON BUTTON
See Figure 2, page 10.
The tool is equipped with a lock-on feature, which is
convenient for continuous use for extended periods of time.
To lock-on:
„ Depress the switch trigger.
„ Push in and hold the lock-on button, located on the side
of the handle.
„ Release the switch trigger.
„ Release the lock-on button.
„ To release the lock, depress and release the switch trigger.
VARIABLE SPEED DIAL/LOCK OUT
See Figures 3 - 4, pages 10 and 11.
The variable speed dial, located on the top of the tool, allows
the multi tool to operate at different speeds or to be set in
a locked position. The maximum speed can be adjusted
before or during operation.
NOTE: The "0" position acts as a tool lock out. The tool will
not operate when the variable speed dial is fully rotated right
to the "0" position.
„ The tool is in the LOW position when the variable speed
dial is rotated to the "1" position.
NOTE: You should feel the dial click into the detent when
the dial is turned.
„ Continue rotating the dial left to select higher speeds.
„ Rotate the dial right to decrease speed.
„ Depress the switch trigger to begin operation.
NOTE: Running at low speeds under constant usage may
cause the tool to become overheated. If this occurs, cool the
tool by running it without a load and at full speed.
LED WORKLIGHT
The LED worklight located on the front of the tool illuminates
when the switch trigger is depressed. If the tool is not in use,
the time-out feature will cause the light to shut off. The LED
worklight illuminates only when there is a charged battery
pack in the tool.
6 — English