SANZ Clima Dreiha CBX 90N Manual página 11

Function and operation
TEMPERATURE CONTROL
SET SWITCH
ON/OFF SWITCH
LED DISPLAY
Power Supply: DC 12V/24V or AC 100-240V power (using dedicated adapter).
Display screen initialization: when the fridge is powered on, the buzzer will make a long beep, and the display
will be on for two seconds the enter the normal operation.
Power ON/OFF: press to switch ON/OFF.
Switch refrigeration/freezer: press to switch refrigerator (the screen will flash "rE") or freezer (the screen
will flash "Fr").
Temperature setting: press or for temperature setting. The setting will be saved automatically after
stopping operating for 4 seconds (Note: the temperature displayed is the current temperature of the
compartment, it´ll take a while to reach the set temperature).
Battery protection mode: under the running state, long press for 3 seconds until the left screen flashes,
then press again to switch High, Medium and Low (*Factory setting is High).
From left to right: Low / Medium / High.
Voltage preference:
*The voltage is a theoretical value, there may be a deviation in different sceneries
* H should be set when the product is connected to car power, and M or L should be set when it is connected to a portable
battery or other back-up battery
Temperature unit setting: switch off the fridge, long press for 3 seconds until displays E1, and switch to
E5 by pressing again, then press or to switch Celsius or Fahrenheit. (*Factory setting is °C).
Reset: switch on the fridge, long press for 3 seconds until displays E1, under E1 mode, long press at
the same time for seconds to reset the settings.
10
90N