Publicidad
Idiomas disponibles
Idiomas disponibles
EN
9. TROUBLESHOOTING
Refrigerator does not work:
• Check if the refrigerator is switched on.
• Check if the plug and socket are connected.
• Check if the fuse has been burnt.
• Check if the power supply is malfunctioned.
• Switch ON/OFF the fridge frequently may cause start delay of the compressor.
Refrigerator compartments are too warm:
• The door is opened frequently.
• A large amount of warm or hot food was stored recently.
• The refrigerator has been disconnected for a long time.
Food is frozen:
• The temperature was set too low.
There is „water flow" noise from inside the refrigerator:
• It's a normal phenomenon, caused by the flow of refrigerant.
There are waterdrops around the refrigerator casing or door gap:
• It's a normal phenomenon, the moisture will condense to water when it touches a cold surface of
the refrigerator.
The compressor is slightly noisy when starting:
• It's a normal phenomenon, the noise will be reduced after the compressor works stably.
Error code overview
Code F1 is displayed:
• Possible cause: Low voltage. Adjust the battery protection from High to Medium or from Medium
to Low.
Code F2 is displayed:
• Possible cause: Condenser fan is overloaded. Disconnect the power supply to the fridge for 5 min-
utes & restart. If the code is still displayed, contact dealer/manufacturer for service.
Code F3 is displayed:
• Possible cause: The compressor starts too frequently. Disconnect the power supply to the fridge
for 5 minutes & restart. If the code is still displayed, contact dealer/manufacturer for service.
Code F4 is displayed:
• Possible cause: Compressor not kicking in. Disconnect the power supply to the fridge for 5 min-
utes & restart. If the code is still displayed, contact dealer/manufacturer for service.
Code F5 is displayed:
• Possible cause: Overheating of the compressor & electronics. Disconnect the power supply to the
fridge for 5 minutes & restart. If the code is still displayed, contact dealer/manufacturer for ser-
vice.
Code F6 is displayed:
• Possible cause: No parameter can be detected by the controller. Disconnect the power supply to
the fridge for 5 minutes & restart. If the code is still displayed, contact dealer/manufacturer for
service.
CARBEST Compressor fridge LR40L / LR50L / LR90L | 713505 / 713506 / 713507
24
Publicidad
