Publicidad
Idiomas disponibles
Idiomas disponibles
PARTS
1. On/off switch
2. Main blade
3. Adjustable beard comb 2 – 18mm
4. Length position indicator
5. Charger connector
6. Charging indicator light
7. Rotary trimmer head
8. Precision trimmer head
CHARGING YOUR BEARD TRIMMER
It is recommended to fully charge your appliance before using it for the first time.
•
Ensure the product is switched off.
•
Connect the product to the USB cable and then to the USB end of the cable to a powered USB
port.
CHARGING INDICATOR LIGHTS
When charging, the charge indicator will come on. When fully charged the indicator will stay on.
•
Run time from fully charged is up to 45 mins.
•
Charge time from empty is 16 hours.
•
Do not recharge your product Aftereachuse as this will shorten the life of the battery.
•
Note: To preserve the life of your batteries, let them run out every 6 months then fully charge.
INSTRUCTIONS FOR USE
BEFORE YOU BEGIN
•
Comb facial hair with a fine comb before you start trimming.
ATTACHING AND REMOVING THE BEARD COMB
•
Make sure that the comb lock is in the down (unlocked) position.
•
Slide the comb down the grooves until it clicks into place.
•
To remove, make sure that the comb lock is in the down (unlocked) position then slide the comb
off the trimmer.
ADJUSTING THE TRIM LENGTH
•
The beard comb can be adjusted to give you 9 different trim lengths.
•
To adjust, make sure the comb lock is in the down (unlocked) position and slide the comb up or
down until the desired length is in the length position indicator window.
•
Lock the setting by sliding the comb lock button up to the locked position.
•
Use the beard trimmer without the adjustable comb for trimming hair close to the skin. This will
trim hair to 1mm, holding the blades perpendicular to the skin will trim hair to 0.4mm.
9. Adjustable stubble comb
10. Battery compartment
11. Comb lock
12. Detail trimmer handle
Not Shown:
• USB charging cable
• Storage pouch
BEARD TRIMMER
5
Publicidad
