Publicidad
1. Press the On / Off Switch until the green LED is
lit. The green LED shows the power level. Press
the minus sign (-) on the speed control to select a
lower cutting speed if needed.
2. Push the Safety Lock Off Lever forward first, then
squeeze and hold the throttle trigger to start the
machine.
Selecting the speed
2 Power Levels can be selected depending on the
application. Use the +/- to control the speed, which
is as indicated by the LEDs. The higher the power
level, the faster the tool runs.
For Battery tools
The recommended ambient temperature range for
discharging is -20°C ~45°C (-4°F~113°F).
The recommended ambient temperature range for
the charging system during charging is
-5°C ~45°C (23°F~113°F).
TRANSPORTATION
Transporting the battery
1. Ensure the battery is in a safe condition.
2. Use non-conductive packaging when
transporting the battery.
EN
3. The contained Li-Ion batteries are subject to the
dangerous goods legislation requirements.
Transport batteries only when the battery
housing is undamaged. Pack up the batteries in
such a manner that cannot move around in the
packaging.
MAINTENANCE
WARNING! Always remove battery before
conducting any maintenance.
Cleaning the air filter (See Fig. F1, F2)
F1
10
F2
1. Clean the area around the air filter. Use a damp
cloth or a soft brush.
2. Unscrew and remove the air filter.
3. Wash the air filter with running water to remove
the dirt.
4. Allow the air filter to dry in the air. And then install
it in the housing by thghtening the screw.
Maintenance intervals
It is recommended to lubricate the gearbox and
clean the air filter every 50 hours of operation based
on actual usage.
CLEANING
1. Do not use aggressive detergents or solvents.
Clean the machine after use with a damp cloth
dipped in mild detergent.
2. Keep battery connection free of dirt and debris,
and clean with a soft and dry brush or cloth.
3. Do not spray water onto the motor and electrical
components.
4. Do not use pressure washer to clean your
machine.
STORAGE
1. Remove the battery pack before storage.
2. If the machine becomes wet in the rain during
operation, the machine and the battery should
be dried before storing or charging. Remove the
battery and reinsert it if the machine fails to turn
on.
3. Store the battery only within a temperature
o
range between 5
C (41
example, do not leave the battery in the car in
summer time.
o
o
o
F) and 25
C (77
F). As an
Publicidad
