Publicidad
Idiomas disponibles
Idiomas disponibles
C1
C2
1
1. Slide the battery pack into the battery
compartment until you hear a click.
2. Press the battery pack release to release battery
pack from your tool.
Charging your battery pack (See Fig. C3)
C3
A
The Li-ion battery is protected against deep
discharging. When the battery is depleted, the
machine is switched off by means of a protective
circuit. Each battery must be fully charged before the
first use.
Testing the machine and battery
(See Fig. D1)
Checking the controls
Safety Lock Off Lever and Throttle Trigger
1. Remove the battery.
2. Try to press the Throttle Trigger. If the Throttle
Trigger can be pressed without pushing the
Safety Lock Off Lever, the Safety Lock Off Lever
is defective. Stop using the machine and contact
the service agent.
4. Push the Safety Lock Off Lever first, then press
the Throttle Trigger.
5. Release the Throttle Trigger and the Safety Lock
Off Lever. If the Throttle Trigger or the Safety
Lock Off Lever is stuck and cannot spring back
to its original position. Stop using the machine
and contact the service agent.
Checking the display
1. Insert the battery.
2. Press the on / off switch. The product is switched
on when the LED (a) is lit. The product is
switched off when the LED (a) is out.
3. Push the Safety Lock Off Lever forward first, then
2
squeeze and hold the throttle trigger to start the
machine. (See Fig. E)
4. If the warning indicator (b) is flashing, refer to
your dealer for solutions.
5. Release the throttle trigger. The machine stops
after a short delay. If the machine continues to
operate, remove the battery and contact the
service agent.
D1
b
a
EN
9
Publicidad
