Publicidad
Idiomas disponibles
Idiomas disponibles
en-us_main.book.book Page 19 Tuesday, February 13, 2024 3:18 PM
5
Hold the water supply connection and gently
push in the collet
d
supply line as shown. Insert the tube at least
5/8 inch (15 mm) into the connector. Insert
the clip on the joint to fasten the tube in place.
• Connections may vary by model.
† This feature is only available on some
models.
†
Type A
†
Type B
NOTE
• Disassembling/Assembling the Water Lines
Collet
Tube
Insert line
e
f
g
• Gently press the collet and insert the tube until
only one line shows on the tube.
to connect the water
Clip
h
6
Place the cover
in place. Insert and tighten
i
the cover screw
.
j
Connecting Refrigerator to
Water Supply
This feature is only available on some models.
Before Beginning
These instructions assume you have an existing
water supply connection for the refrigerator. If
necessary, call a qualified plumber to install a
water supply line for the refrigerator.
• Turn the icemaker OFF if the refrigerator will be
used before the water line is connected.
• Do not install the icemaker tubing in areas
where the ambient temperatures fall below
freezing.
WARNING
• Connect to potable water supply only.
CAUTION
• To prevent burns and product damage, only
connect the refrigerator water line to a cold
water supply.
• Wear eye protection during installation to
prevent injury.
Water Pressure
You will need a cold water supply.
Water Pressure
• Models with water filter:
- 20 - 120 psi (138 - 827 kPa)
INSTALLATION
19
Publicidad
