Adjusting Display Light Level; Manual Assignment Of Zone Address For Intercom Microphone Base 13503 (Series 400 Only); Manual Selection Of Installation Type; Factory Reset - EIS 400 Serie Manual De Uso E Instalación

3. User Manual
19
ENG

3.5. Adjusting Display Light Level

Key 912 followed by pressing the
9
PRG button.
Define the display light level by choosing
a value between 1 (minimum), 2
(medium), 3 (high) and 4 (maximum)
and press the PRG button to confirm.
3.6. Manual Assignment of Zone Address for
Intercom Microphone Base 13503
(Series 400 only)
Each and every Series 400 device installed is identified by a zone address that must
be unique to each one and have a value between 1 and 250 (see CC-1034 The
400 Series User and Installation Manual).
Each time the microphone base is connected to an installation, it initiates the
automatic process of assigning an address that is not being used at the time.
However, if the user wishes, the address can be changed by following these steps:
Key 913 followed by pressing the PRG
button.
Define an address between the values
of 1 and 250 (for example, 192) and
press the PRG button.tecla PRG.
The microphone base will then verify whether or not the address is available
and, if so, will take it as its own. If, however, the address has already been
assigned to another element in the installation (a control unit, a PC interface or
another base), it will restart the process.
EIS
1 2
light level
PRG PRG
4
PRG PRG
9 1 3
ADDRESS
PRG PRG
1 9 2
192
PRG PRG
3.7. Manual Selection of
Installation Type
The first time that the microphone base is powered must be
defined the type of installation to which it is connected: 400
Series, New 100 Series or New 100 Series with call extension.
In any event, there is an option to allow for the manual selection
of this type of installation:
9
Key 914 followed by
pressing the PRG button.
Key 1 and then PRG for the New 100
Series, only general call (see E100/1
diagram)
Key 2 and then PRG for the New 100
Series with zone extension (see E100/2
and E100/3 diagrams)
Key 3 and then PRG for the 400 Series
(see E400 diagram)

3.8. Factory Reset

To reset programmed data
9
and return to the
microphone base's factory
configuration, key 951
followed by pressing the
PRG button.
EIS
1 4
SERIE
PRG PRG
1
1
PRG PRG
2
2
PRG PRG
3
3
PRG PRG
5 1
RESET
PRG PRG