Samson Stage v166 Manual De Propietario página 10

Quick Start Guide
3. While holding the upper section of the
HT6 transmitter, rotate the bottom section
and slide down to expose the battery
compartment.
Insert a standard 9-volt alkaline battery, being
sure to follow the plus and minus polarity
markings.
4. Turn on the HT6 transmitter by sliding the POWER switch
to the right, and replace the bottom section.
5. Place the SR166 receiver where it will be used (the general rule of thumb is to maintain "line
of sight" between the receiver and transmitters so that the person(s) using the transmitter can
see the receiver). Turn on the power of the SR166 receiver.
6. Turn on the connected amplifier and/
or mixer, but keep its volume all the
way down. Next, make sure that your
transmitter is un-muted by setting
its Audio switch to ON. Then, set the
Volume Control knob on the SR166
fully clockwise; this is unity gain.
Speak or sing into the mic at a normal
performance level while slowly raising
the volume of your amplifier/mixer until
the desired level is reached.
10 Stage v166: Handheld Wireless System