Connect Drain Hose - Maytag Commercial MAT20CSAGW Instrucciones De Instalación

CONNECT DRAIN HOSE

Proper routing of the drain hose avoids damage to your floor
due to water leakage.
Remove drain hose from the washer basket
1. Remove cap from the washer drain port on the back
of the washer.
2. If clamp is not already in place on elbow end of drain hose,
slide it over end as shown.
3. Squeeze clamp with pliers and slide elbow end of drain
hose onto washer drain port and secure with clamp.
4. The washer drain system can be installed using a floor drain,
wall standpipe, floor standpipe, or laundry tub.
5. Place hose into standpipe (shown in picture) or over side
of laundry tub.
IMPORTANT:
D rain hose is not to exceed 203 mm (8") into drain pipe;
n
do not force excess hose into standpipe or lay on bottom
of laundry tub. Drain hose form must be used.
I t is the responsibility of the installer to install and secure
n
the drain hose into the provided plumbing/drain in a
manner that will avoid the drain hose coming out of,
or leaking from, the plumbing/drain.
Drain
hose
form
203 mm
8"
(8")
(203 mm)
6. For floor drain installations, you will need to remove the drain
hose form from the end of the drain hose. You may need
additional parts with separate directions. See "Tools and Parts."
7. The floor drain system requires a siphon break that may be
purchased separately. The siphon break (Part Number 285320)
must be a minimum of 710 mm (28") from the bottom of the
washer. Additional hoses might be needed.
710 mm
(28")
11