Philips HD2650 Manual Del Usuario página 5

guarantee leaflet). If there is no Consumer Care
Centre in your country, go to your local Philips
dealer.
Before first use
Put the toaster in a properly ventilated room
and select the highest browning setting. Let
the toaster complete a few toasting cycles
without bread in it. This burns off any dust
and prevents unpleasant smells.
Toast, reheat, or defrost bread (fig.2)
Note:
•
Do not operate the appliance without
the crumb tray.
•
Never force bread into toasting slots.
Never toast bread slices that have been
buttered. Take extra care when toasting
breads that contain sugar, preserves,
raisins or fruit bits, due to risk of
overheating. Do not use bent, damaged
or broken bread slices in your toaster as
it may get jammed into the slot or stuck
in the toasting chamber.
To toast bread, follow the steps 1, 2, 3, 4.
•
Select a low setting (1-2) for lightly
toasted bread.
•
Select a high setting (6-8) for darkly
toasted bread.
To reheat bread, press the reheating setting
button ( ).
To defrost bread, press the defrosting setting
button ( ).
Note:
•
You can stop the toasting process
and pop up the bread at any time by
pressing the stop button (STOP) on the
toaster.
Tip:
•
You may use different browning settings
when toasting different types of bread:
•
For dry, thin or stale bread, select a
lower setting. This type of bread has
less moisture and it will go brown
quicker than moist, thick or fresh
bread.
•
For fruit bread like raisin bread,
select a lower setting.
•
For higher sugar content bread,
select a lower setting.
•
For heavier textured bread like rye
bread or whole wheat bread, select
a higher setting.
•
When you toast one slice of bread,
browning of toast may be slightly varied
from one side to the other.
•
For bread that may have loose food
bits, for example raisin bread and whole
wheat bread, remove the loose bits
before putting bread slices into the slot.
This can avoid potential flame/smoke
resulting from loose food bits dropping/
sticking in the toaster chamber.
Bun warming (fig.3)
To warm buns, follow the steps below:
a Push down the warming rack lever to
unfold the warming rack.
b Turn the browning control to the bun
warming setting (
Note:
•
Do not place bread on bun warming
rack to avoid damage to toaster.
•
Never put the rolls to be warmed up
directly on top of the toaster. Always use
the warming rack to avoid damage to
the toaster.
Cleaning (fig.4)
Warning:
•
Never use scouring pads, abrasive
cleaning agents or aggressive liquids to
clean the appliance.
•
Lightly tap the toaster housing to
dislodge any bread crumbs in the
toaster chamber.
•
Allow toaster to cool down for 30
minutes after use before cleaning the
toaster.
).
EN 9