Publicidad
Idiomas disponibles
Idiomas disponibles
BOTTLE JACKS
ESSENTIAL SAFETY REQUIREMENTS
Read the instruction manual carefully and practice with the equipment prior to application.
The bottle jack has been designed to lift vehicles. Other industrial uses are foreseen only when they are not continuous and the
operator takes into consideration the safety measures corresponding to the application.
Use safety gloves and, for industrial applications, safety goggles and boots.
The jack and the vehicle must be on a flat surface.
Choose an apparatus that does not exceed 80% of its nominal capacity both in load and elevation.
Look for stable zones for the load application points and safe areas for the operators. Use chocks if necessary.
Do not work underneath the vehicle. If absolutely necessary, mechanically block using axel stands.
Make use of the whole support surface of the jack both at the head and base.
Do not expose equipment to sources of intense heat (welding).
Carry out maintenance operations when the equipment is load free and in clean well-illuminated places.
The jack handle is used for pumping as well as for opening and closing the release valve. Do not use longer handles or any
other type of tool to operate the jack.
Once the equipment has been used, check that it has not been damaged, clean and protect before storage.
On filling the jack with oil, use LARZEP hydraulic oil or one of similar characteristics. Fill only as far as the level marked
(rubber stopper) and bear in mind that the piston must be set back.
Before carrying out any type of application make sure the jack is well installed, check the safety of the operator position and
make sure it is impossible for any person to gain access to the lifting area.
The jacks have a pressure regulating valve incorporated, calibrated in factory. Do not manipulate this valve.
HOW TO USE
Before using the jack, the internal circuit must be drained. To do so, open the release valve by turning to the left, a couple of
turns and pump the jack 8 times.
Close the release valve, turning to the right as far as it will go (it is not necessary to tighten with force). The jack is now ready
to be used.
Using the spindle (if available) move the head of the jack closer to the load application point.
Raise the vehicle by pumping. Be aware of safety norms at all times.
To lower the vehicle, turn the discharge valve slowly to the left.
Pick up the jack (spindle and piston), clean and store for future use.
The jack can be used in a horizontal position on other types of applications, only when the injector equipment (pump) is
situated in the lower part.
MAINTENANCE
Periodically grease the pieces that are subject to friction, the injector, the spindle, etc.
Check the oil level and top up if necessary. The level is marked by the spill over of oil from the filling hole (rubber stopper on
the side of the jack), keeping the jack in a vertical position and the piston in. Excess oil may impede the correct functioning of
the jack.
Use LARZEP hydraulic oil. Under no circumstances should you use brake fluid, transmission fluid or common oil.
In maintenance operations use original LARZEP parts. The reference for the set of spare parts is created by putting JR. before
the jack reference.
All repairs must be carried out by qualified personnel.
DIMENSIONS
Capacity
Reference
Tn
A40211
2
3
A40311
A40515
5
A40815
8
A41015
10
A41515
15
4
AB40434
Closed height
Extended height
mm
172
172
212
220
220
231
265
Stroke
mm
mm
372
112
372
112
468
146
483
148
483
148
498
154
610
345
Base
Screw
mm
mm
103 x 105
88
103 x 105
88
110 x 112
110
124 x 127
115
124 x 127
115
140 x 142
113
124 x 128
-
Weight
kg
3,9
3,9
5,0
7,5
7,5
10,1
7,5
Publicidad
