Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
.
Allow 30 minutes for proper cleaning. After cleaning,
shut off the power switch, and
unscrew the nut of the water-draining
hole on the rear of the unit. Drain off the waste
water to some container,
and then screw the nut on tightly when the waste water is
fully drained off.
The ice machine cleaner contains acids.
DO NOT
use
or mix with
any other
solvent-based
cleaner
products.
Use rubber gloves to protect hands.
Carefully
read the material
safety instructions
on the container
of the ice machine cleaner.
DISCARD
the first batch of ice produced
after cleaning.
6. Repeat steps 4 and 5 (without Ice Maker Cleaning Solution) to rinse the ice making
system 3 times.
NOTE: The use of the Ice Maker Cleaner Solution #1 the water sump during the rinse
is not needed.
.
Prepare
a sanitizing
solution
made
of 1 ounce
of household
bleach
and 2 gallons
of
hot water
(95 ° to 115 ° F). Remove
the flake covers
and slideway
from the water
sump
and wipe the entire
bin inside
and out, covering
the entire
surface
of the walls.
.
Fill a spray bottle with the sanitizing
solution and spray all corners and edges, making
sure to cover all surfaces with the solution. Soak the flake covers and slideway in the
solution and put back in place after drying.
9. Allow the solution to be in contact for at least 3 minutes, then dry.
10. Repeat step 6 to rinse the ice making system one more time.
11. Reassemble
the front cover.
12. Turn on the power again. The machine will return to the regular ice making mode.
Discard the first batch of ice.
23
Publicidad
Capítulos
Tabla de contenido
