Kenmore 385.17124 Manual De Instrucciones página 32

Threading the Machine
o Threading the Machine
Raise the thread take-up lever to its highest
position by turning the handwheel
counterclockwise.
•' Raise the presser foot lifter.
Place a spool on the spool pin, with thread coming
off as shown.
1_ Draw the end of thread around the upper thread
guide.
_2_ While holding the thread near the spool, draw the
end of the thread down around the check spring
holder.
(_) Firmly draw the thread up from right to left over
the take-up lever and down into the take-up lever
eye.
(_ Slide the thread behind the needle bar thread
guide on the left.
(_) Thread the needle from front to back or use a
needle threader.
We recommend using the convenient needle
threader(#200262101), included with your
machine.
o Drawing up Bobbin Thread
(_ Raise the presser foot. Hold the needle thread
lightly with your left hand and rotate handwheel
counterclockwise for one complete turn.
(_ Bring the bobbin thread up by pulling the needle
thread up.
(_ Pull both threads under and to the back of the
presser foot, !eaving 10 to 15 cm (4 to 6 inches)
of thread clear.
t
P
24