Installation; Installing The Lithium Battery - Sony RM-X7BT Manual De Instrucciones

Ocultar thumbs Ver también para RM-X7BT:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation

Installing the lithium
battery
1
Open the cover on the bottom
of remote commander with a
coin, etc.
2
Install the supplied lithium
battery  to the remote
commander.
To replace the lithium battery
Under normal conditions, the
battery will last approximately 1
year. (The service life may be
shorter, depending on the
conditions of use.)
+ side up
When the battery becomes weak,
the range of the remote
commander becomes shorter.
CAUTION
Danger of explosion if battery is
incorrectly replaced. Replaced
only with the same or equivalent
type.
Notes on the lithium battery
 Keep the lithium battery out of the
reach of children. Should the
battery be swallowed, immediately
consult a doctor.
 Wipe the battery with a dry cloth to
ensure a good contact.
 Be sure to observe the correct
polarity when installing the
battery.
 Do not hold the battery with
metallic tweezers, otherwise a
short-circuit may occur.
Installing the remote
commander
Before installing
 Make sure that the angle of slant
at the holder  or the direction
of remote commander is
suitable for the installation site.
There are 4 grooves on the
remote commander and 2 hooks
on the holder , and
depending on the situation, you
can install the remote
commander four different ways.
7
GB

Publicidad

Tabla de contenido
loading

Tabla de contenido