SEVERIN SM 3584 Instrucciones De Uso página 13

Operation
Stirring tool
∙ For frothing milk, use the stirring tool
with coil attachment.
∙ For heating milk, use the stirring tool
without coil attachment.
Note!
Should the inner ring inside the coil
attachment be jammed or canted, the
coil attachment becomes too wide and
does no longer precisely fit the stirring
tool. In this case, detach the two ends of
the inner ring and re-align them, with the
ends properly aligned.
Fill amounts
∙ MIN
minimum quantity of milk 75 ml
∙ MAX &
maximum quantity of milk for frothing:
100 ml (lower max mark)
∙ MAX
maximum quantity of milk for heating:
200 ml (upper max mark)
Preparing the appliance
∙ Remove the lid from the milk container.
∙ For frothing milk, fit the coil attachment
to the stirring tool.
∙ Put the required amount of milk into the
container.
∙ Place the lid on the container.
∙ Insert the plug into the wall socket.
∙ Place the milk container onto the base.
Hint:
We recommend using milk with a
high protein content. For best results,
the milk should be taken from the
refrigerator immediately before frothing.
Preparation
∙ Press the FUNCTION button:
1x: more milk froth, less milk
2x: less milk froth, more milk
3x: heating only
4x: cold frothing
The selected function starts flashing.
∙ Press the ON/OFF switch to start
processing.
∙ The selected function is lit and the milk
processing starts.
∙ Once processing is complete, the
heating and stirring process stops
automatically. Beep signals are heard
and the function lights are flashing.
∙ You can now remove the milk container
from the base.
∙ Pour out the milk, or use a suitable
spoon to take off the milk froth.
∙ Detach the power cord from the wall
socket after use.
Remark
Always allow the appliance to cool down
first, and then clean it, before starting a
new cycle.
Hint:
To achieve a thicker froth, go through
a cold-frothing cycle first, followed by a
hot-frothing cycle.
13