Hama PD-27W60 Instrucciones De Uso página 4

4. Operation
4.1 Charging the Power Pack
• Begin charging the power pack by connecting the included USB-C charging cable to the power
pack's USB-C input (IN 5V/3A; 9V/2A; 12V/2A; 14.5V/1.5A; 20V/1.5A) and to a suitable PD
charger. Alternatively, you can charge the power pack using a USB-A to USB-C charging cable and a
suitable USB charger. Please refer to the operating instructions for the USB charger used.
• Charging begins and ends automatically.
• Charge the Power Pack fully before using it for the first time.
Note – Capacity
• The capacity is always shown when the Power Pack is charging.
• Each status LED corresponds to 25% of the capacity. When an LED is permanently illuminated,
this indicates that this capacity level has already been reached. The Power Pack is charged to at
least 75% if three LEDs are illuminated, and the fourth is flashing.
• If all four status LEDs light up, the full capacity is available.
• Press the button of the Power Pack to switch it on and to check its current capacity.
• The power pack switches off automatically after about 10 seconds.
Warning – Battery
• Only use suitable charging devices or USB connections for charging.
• As a rule, do not charge devices or USB connections that are defective and do not try to repair
them yourself.
• Do not overcharge the product or allow the battery to completely discharge.
• Avoid storing, charging or using the device in extreme temperatures and extremely low
atmospheric pressure (for example, at high altitudes).
• When stored over a long period of time, batteries should be charged regularly (at least every
three months).
4.2 Charging terminal devices
• Connect the included USB-C charging cable to the power pack's USB-C connection (see 8.
Technical Data) and to the USB-C connection of your terminal device (smartphone, tablet,
notebook, etc.) to charge your terminal device with Power Delivery. Alternatively, connect a
suitable charging cable for your terminal device to one of the two USB outputs to charge your
terminal device.
• Charging begins automatically. The status LEDs show the remaining capacity when the Power Pack
is charging.
• The current battery status of your terminal device will appear on this device.
• Charging ends automatically. Then disconnect the power pack from your terminal device.
• The Power Pack will automatically switch off if it is not connected to a terminal device.
Warning – Connecting terminal devices
• Before connecting a terminal device, check whether the power output of the charger can supply
sufficient power for the device.
• Ensure that the total power consumption of the connected terminal device does not exceed the
limit value (see point 8 Technical Data).
• Please refer to the instructions in the operating manual of your terminal device.
• It is essential that you observe these specifications and the safety instructions regarding the
power supply of your devices.
• The power pack must not be charged and discharged at the same time!
3