YEAZ SUP Board Manual Del Usuario página 23

Small repairs:
Let the air out first. Clean the board thoroughly (vinyl cleaner can be used
for this purpose) and dry the area to be repaired. For a smaller hole, apply
a small drop of glue (not included). Allow the glue to dry for 12 hours. (For
smaller repairs, use a soft plastic adhesive that is waterproof and heat
resistant).
Please note: For the repair, the air must be vented and the board must lie
flat.
1. Thoroughly clean the area surrounding the leak. Remove any dirt.
2. Cut off a piece of the original patch. The piece should be large enough
to overlap the damaged area by about 1.5 cm. Use a ballpoint pen to
determine the size of the patch. Round off the corners.
3. Apply a thin layer of adhesive to the underside of the patch and the area
to be repaired. Allow the glue to dry for 2 - 4 minutes until it appears
milky.
4. Place the patch on the damaged area and press firmly. Please do not
use the board for the next 24 hours to allow the glue to cure completely.
23