How To Use - Fenix TR3-700 Instrucciones

ENGLISH

4. HOW TO USE

1. Place the ground support tower over a firm
and flat surface on its working place.
2. In case it is not already, put the section(T1)
on the base (B) and introduce the chariot (C).
3. Insert the outriggers (A) fully into its hou-
sing, make sure that the (S) is properly ope-
rated and stabilize the tower with the stabi-
lizers (E).
4. Attach the section (T2) with hinges at its
end with the section already placed on the
base, put the hinge pins on the side facing
the area where the trusses will be placed for
lifting, place the following truss sections (T3)
(T4) connected to the section already insta-
lled and put all the pins to the trusses, place
the head (V) at the end of the last section.
5. Once the sectionsare assembled horizon-
tally, attach the hoist (H) through the upper
hook in the head ring (N), in case of using
motor, pass the chain over the pulleys (V)
before elevation.
V
10 10
T1
A
N
H
T4 T3
J
6. With the hoist placed, raise the trusses by
hand and place them completely vertical, put
the two remaining pins (Y) to the two free
hinges.
7. Attach the hook (J) of the chain hoist or
motor to the shackle (G) of the chariot and
proceed to is lifting.
8. Once the trolley is halfway up, put the
straps (R).
9. To change or add points of connection to
the car, it is advised to remove the carriage
from the tower, unscrew the connectors with
an allen wrench size 8 and then screw again
in the corresponding position.
10. For the process of lowering and folding,
reverse the order of the steps.
WE RECOMMEND ASSEMBLING THE
PERIMETER TO THE FACES OF THE
CARRIAGE BEFORE RAISING THE
C
B
Y
T2
A
ATTENTION:
TOWER
E
S
J
R
G