LD Systems LDMS828 Manual De Usuario página 8

CONNECTIONS:
12
MAIN IN LEFT/RIGHT
Balanced XLR stereo input left and right.
13
MAIN OUT LEFT/RIGHT
Balanced XLR stereo output left and right.
14
INPUT CHANNEL 1 - 6
Balanced line inputs. Channels 1 - 4 have female XLR sockets; channels 5 and 6 have 6.3 mm stereo TRS
sockets. In order to make a connection with the TRS inputs, unbalanced cables with mono jack (TRS) plugs
can also be used. However, the balanced connection is preferable to the non-balanced connection.
15
OUTPUT CHANNEL 1 - 6
Balanced line outputs. Channels 1 - 4 have male XLR sockets; channels 5 and 6 have 6.3 mm stereo TRS
sockets. In order to make a connection with the TRS outputs, unbalanced cables with mono jack (TRS) plugs
can also be used. However, the balanced connection is preferable to the non-balanced connection.
16 GROUND LIFT
Switch in "Lift" position (right switch position) can prevent ground loop hum if devices with varying ground
potential are connected. If the switch is in "Ground" position (left switch position), then the ground lift
function is deactivated.
17
IEC POWER SOCKET WITH INTEGRAL FUSE HOLDER
IMPORTANT INFORMATION: Make certain BEFORE turning on the equipment that the mains voltage of your
energy supplier and the operating voltage of the device match! Always replace the fuse only with a fuse of
the same type with the same rating (printed on the rear panel)! If the fuse blows repeatedly, please contact
an authorised service centre.
8
13 12