Product Specifications - Philips Fidelio B1 Manual Del Usuario

5
On the remote control, within 6 seconds
twice then Volume + once, and
press
then hold down MOVIE.
» Then "UPG" (upgrade) is displayed on
the display panel.
» If a USB flash drive is not connected or
invalid upgrade file is found, "ERROR"
(error) is displayed on the display
panel.
6
When "UPG" blinks, press
remote control to start the upgrade.
7
Wait until the upgrade is completed.
» If the upgrade is complete, this product
automatically turns off and on again.
Note
•
The upgrade time may take around 3 minutes.
14 EN
on the
6 Product
specifications
Note
•
Specifications and design are subject to change without
notice.
Amplifier
• Total output power:
320W RMS (+/- 0.5 dB, 10% THD)
• Frequency response: 20 Hz-20 kHz / ±3 dB
• Signal-to-noise ratio: > 65 dB (CCIR) /
(A-weighted)
• Input sensitivity:
• AUX: 1900 mV
• AUDIO IN: 900 mV
Audio
• S/PDIF Digital audio input:
• Optical: TOSLINK
USB
• Compatibility: Hi-Speed USB (2.0)
• Class support: USB Mass Storage Class (MSC)
• File system: FAT16, FAT32, NTFS
• Playable audio files: .aac, .mp3, .m4a,
Bluetooth
•
Bluetooth profiles: A2DP, AVRCP
•
Bluetooth version: 4.1
•
Frequency band/Output power:
2400 - 2483.5 MHz / ≤ 20 dBm
•
NFC frequency: 13.56 MHz
Wireless speaker link
•
Frequency band: 5740-5840 MHz
•
Output power: ≤ 14 dBm