LAVOR Pro THERMIC 10 D Manual Del Usuario página 17

FAULT
The pump doesn't reach Water inlet filter is clogged
the necessary pressure Suction/delivery valves are clogged
or worn out
Lance nozzle incorrect or worn out
Fluctuating pressure Air intake
Valves dirty, worn out or stuck
Sealing worn out
Water leaking from the Sealing worn out
pump
Loss of pressure The nozzle is worn out
The valves are dirty or blocked
Adjusting valve seal is worn out
Seals are worn out
The filter is dirty
Noise Air intake
Valves are worn out dirty or blocked
Bearings are worn out
Extreme water temperature
The filter is dirty
Water is in the oil O-rings (water and oil) are worn out.
High moisture in the air
Water leakage from the Seals are worn out
head O-rings seal system are worn out
Lance blocked Nozzle is dirty
3 2 4
5
CAUSE
Clean the water inlet filter
Contact an authorised service centre
Check and/or replace
Check that connections and locking
ring are well tightened
Contact an authorised service centre
Contact an authorised service centre
Contact an authorised service centre
Replace the nozzle
Contact an authorised service centre
Contact an authorised service centre
Contact an authorised service centre
Check and/or clean
Check the intake pipes
Contact an authorised service centre
Contact an authorised service centre
Bring the temperature under 40° C
Check and clean
Contact an authorised service centre
Replace oil with double frequency
that is suggested
Contact an authorised service centre
Contact an authorised service centre
Clean nozzle with the pin included in
the unit
1
8 7 9 10 11
6
REPAIR
17