Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
L
earning
C
K
J
A. Power Cord (Plug
NOT shown)
B. On/Off Button
C. Motor Body
D. Cam Disc
E. Cam Shaft
FPSBCP941_11ESM1.indd 4-5
a
Y
bout
our
P
ookie
ress
A
B
C
E
D
F
G
H
I
F. Tube
G. Pastry Tip Adapter
H. Pastry Tip(s)
I. Pastry Tip Cover
J. Tube Cover
K. Cookie Disc(s)
-4-
H
t
ow
It is recommended to wash all of the cookie press parts except the BODY (C)
with warm, soapy water before first use. Dry these parts thoroughly before use.
NOTE: Don't immerse the BODY (C), CORD (A) and PLUG in any liquid.
1. Turn Cam Disc (D) counter-clockwise until it clicks.
2. By inserting the stem of Cam Shaft (E) into the center hole of the Cam Disc
(D), the Cam Shaft (E) attaches to the Cam Disc (D). By turning clockwise
it will click when it is properly aligned.
3. Select a Cookie Disc (K) and place it into Tube Cover (J).
4. Next, by turning clockwise place Tube Cover (J) into bottom part of the
Tube (F).
5. When using a Pastry Tip (H), fit it over the Pastry Tip Adapter (G) and
secure it with the Tip Cover (I).
6. The pastry tip assembly then goes inside the tube cover (J).
7. Load the prepared cookie dough or filling. NEVER FILL THE TUBE (F)
MORE THAN THE MAX FILL LINE.
8. Furthermore, the ridges on the inside of the Tube (F) need to be aligned
with the outside contours of the assembled discs (D). Align the arrows of
the Tube (F) with the Motor Body (C). Make sure top arrow on Tube (F)
lines up and is in the lock position.
H
t
m
ow
o
1. The consistency of the cookie dough is very important when making
cookies with your Sunbeam
cookie press. When the cookie dough is too
TM
soft, refrigerate it for about 10-15 minutes. On the other hand, when the
dough is too stiff it will not release from the appliance.
TIP: The use of store-bought cookie dough is not recommended.
2. Insert the plug into a 120 volt power outlet when filled with cookie dough.
3. With the cookie press upright press against the surface of the cookie sheet.
4. Press the On/Off button (B) until the air pockets are removed from the tube.
5. Press a cookie for about 2 seconds. Based on the desired thickness and
shape of the cookie the pressing times will vary.
6. When done, release the On/Off button (B) and repeat to the next position
on the cookie sheet.
TIP: When the dough is loaded in the cookie press, use it immediately.
7. When refilling the cookie press with dough, always UNPLUG the unit first.
NOTE: When different type of cookie dough needs to be used, clean the
cookie press before refilling. NEVER IMMERSE THE MOTOR BODY (C)
IN WATER OR ANY OTHER LIQUID.
a
o
ssembLe
C
ake
ookies
-5-
8/15/11 9:19 AM
Publicidad
Tabla de contenido
