Troubleshooting Guide - EINHELL GE-LC 18 Li T Manual De Instrucciones

11. Troubleshooting guide

Danger!
Before troubleshooting, switch off the equipment and remove the battery.
The table below contains a list of fault symptoms and explains what you can do to remedy the problem
if your equipment fails to work properly. If the problem still persists after working through the list, please
contact your nearest service workshop.
Problem
The equipment
does not work
Equipment operates
intermittently
Saw chain is dry
Chain/guide bar
is hot
Chainsaw judders,
vibrates or does not
saw properly
If the equipment will not work in spite of the troubleshooting measures and the voltage supply being OK,
please contact customer service (see section 8.3).
Anl_GE_LC_18_Li_T_USA_Kit_SPK7.indb 19 Anl_GE_LC_18_Li_T_USA_Kit_SPK7.indb 19
EN
Possible cause
- Battery empty
- Battery is not correctly inserted
- Loose connection (external)
- Loose connection (internal)
- ON/OFF switch defective
- No oil in the tank
- Vent in the oil tank cap is blocked
- Oil outlet is blocked
- No oil in the tank
- Vent in the oil tank cap is blocked
- Oil outlet is blocked
- Chain is blunt
- Chain is overtensioned
- Chain is undertensioned
- Chain is blunt
- Chain is worn
- Saw teeth point in the wrong
direction
- 19 -
Remedy
- Charge battery
- Remove battery and insert again
- Consult a specialist workshop.
- Consult a specialist workshop.
- Consult a specialist workshop.
- Top up with oil
- Clean the oil tank cap
- Clear the oil outlet
- Top up with oil
- Clean the oil tank cap
- Clear the oil outlet
- Re-sharpen or replace the chain
- Check the chain tension
- Adjust the chain tension
- Re-sharpen or replace the chain
- Replace the chain
- Refi t the chain with the teeth facing
in the correct direction
24.03.2020 10:47:19 24.03.2020 10:47:19