Maintenance Instructions; Moving And Storage Instructions - Schumacher Electric INC-7A-OBD Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

8.
POWERING A 12V DC DEVICE:
The memory saver is a power source for all 12V DC accessories that are equipped with
a 12V accessory plug. Use it for power outages and fishing or camping trips.
1. Make sure the device to be powered is OFF before inserting the 12V DC accessory
plug into the 12V DC accessory outlet.
2. Open the protective cover of the DC power outlet on the back of the memory saver.
3. Plug the 12V DC device into the DC power outlet, and turn on the 12V DC device
(if required).
NOTE: If the 12V DC device draws more than 9A, the internal circuit breaker of the memory
saver will trip and disconnect the power to the device. Disconnect the 12V DC device. The
breaker will automatically reset after an overload occurs.
4. When finished, turn off the DC device (if required) and unplug from the DC power outlet.
9.

MAINTENANCE INSTRUCTIONS

9.1
Servicing does not require opening the unit, as there are no user-serviceable parts.
9.2
After use and before performing maintenance, unplug and disconnect the memory saver.
9.3
Use a dry cloth to wipe dirt or oil from the cords and the memory saver case.
9.4
Ensure that all of the memory saver components are in place and in good working condition.
9.5
All other servicing should be performed by qualified service personnel.
10.

MOVING AND STORAGE INSTRUCTIONS

10.1
Store the memory saver in an upright position. Store inside, in a cool, dry place.
10.2
If the memory saver is moved around the shop or transported to another location, take
care to avoid/prevent damage to the cords and memory saver. Failure to do so could
result in personal injury or property damage.
10.3
Charge the memory saver's internal battery immediately after purchase, after every
use and every 30 days, to keep fully charged.
Do not power a 12V device with the memory saver while using the OBD
connector to power the on-board diagnostic computer. Doing so will
drain the memory saver's internal battery and reduce available run time.
Extended operation of a 12V DC device may result in excessive battery
drain. Recharge the memory saver immediately after unplugging the
12V DC device.
Do not use and/or store the memory saver in or on any area or surface
where damage could occur if the internal battery should unexpectedly
leak acid.
• 6 •

Publicidad

Tabla de contenido
loading

Tabla de contenido