Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
•
Connect the cord on the power head to the power
supply (Fig. M).
•
Position the tube slightly above the debris/leaves. Turn
the blower/vac on, then using a sweeping motion the
debris/leaves will be sucked up the tube, mulched and
deposited into the collection bag (Fig. O) .
As the collection bag fills, the suction power will decrease.
Turn the blower/vac off and unplug from power supply
before emptying collection bag.
Fig. O
Emptying Back Pack Collection Bag
(Fig. P, Q)
CAUTION: NEVER REMOVE THE COLLECTION BAG
WITHOUT FIRST TURNING OFF AND UNPLUGGING
THE VACUUM.
•
Empty the back pack collection bag
the retaining clip
17
in Fig. P.
Fig. P
nOTE: If the suction decreases and the bag is not full,
the vacuum tube is probably clogged with debris.
Turn off and unplug the blower/vac and clear the tube
before continuing.
•
To re-seal the collection bag
the bag and latch the retaining clip
in Fig. Q.
8
by unlatching
and unrolling the bag as shown
17
8
8
, roll the open end of
17
closed as shown
WARNING: Do not operate blower without blow
tube or flexible collection tube securely in place. Never
reach down into housing through tube hole.
Fig. Q
8
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and unplug before making
any adjustments or removing/installing
attachments or accessories. An accidental start-up
can cause injury.
Cleaning
WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
WARNING: TURN OFF AND UNPLUG TOOL! (Unplug
extension cord at power source.)
Use only mild soap and a damp cloth to clean the tool.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid. Clean out any clippings which
may have accumulated in the Blower/Vac. When used
properly with dry leaves the fan chamber of your Blower/
Vac should remain clean. If damp earth and debris are
ingested some of the particles may build up on the inside
of the fan chamber. If this happens the performance of the
unit will decrease. This area can be cleaned out using a
wooden stick as shown in Fig. R after disconnecting from
the power source. Your Blower/Vac should be stored in a
dry place.
English
17
7
Publicidad
Tabla de contenido
