Installation And Safety Instructions - Kathrein WFS 28 Manual De Instrucciones

Remote feeding diplexer
Features
Remote feeding diplexer with adjustable output voltages:

5/12/14/18 Volt
For remote feeding of BZD 30/BZD 40 DVB-T antennas,

VCA/VCB 20/28 compact amplifi ers, VCP 27/35/45/55/66 low
noise preamplifi ers, UAS 584 feed systems - in conjunction
with the NCF 18 switched-mode power supply unit (not
included with this product)
Proof against overloads and short circuits

Transmission range up to 2.150 MHz

Output with capacitive isolation

For indoor installation



Installation and safety instructions

• The equipment described is designed solely for the installation of satellite and terrestrial receiver systems.
• Any other use, or failure to comply with these instructions, will result in voiding of warranty cover.
• The equipment may only be installed in dry indoor areas. Do not install on or against highly combustible materials.
• The equipment must be provided with an equipotential bonding wire (Cu, at least 4 mm2).
• The safety regulations set out in the current EN 60728-11 and EN 60065 standards must be complied with.
• Fixings: screws, max Ø: 4 mm
• Connectors: RF plug 75 Ω (series F) to EN 61169-24.
Incorrect voltage settings can damage the remotely fed equipment!
The voltage selection switch must be set to the correct voltage before the equipment is connected, and must not
subsequently be changed (see system example page 2).
Only the NCF 18 plug-in power supply unit (not included with this product) may be used to supply power.
• A cable inner conductor diame-
ter greater than 1.2 mm or the
presence of burrs can damage
the product's sockets.
Max. 2 mm protrusion
Tightening torque max. 3
Nm (risk of overtightening)
1 / 2
21210025
WFS 28
Diameter
0.6-1.2 mm burr
free