Using The Led Light; Troubleshooting - EASYHOME MD19143 Manual Del Usuario

Troubleshooting

Using the LED light

Once the product is connected to a power supply, you can turn the LED
light 3 on by pressing the LED on/off button
− Press repeatedly the LED on/off button to set a lighting mode: automatic
color change, violet, indigo blue, light blue, green, yellow, orange, red and off.
− Press the LED on/off button for about 2 seconds to turn off the LED light
from any lighting mode.
Troubleshooting
NOTICE!
Risk of damage!
If you do not use the product properly, you could damage it.
− Do not open the housing; instead, have qualified
professionals perform the repairs. Contact a qualified
repair shop for this. Liability and warranty claims are
waived in the event of repairs performed by the user or
incorrect operation.
Some problems may be caused by minor faults that you can fix yourself. To do
so, follow the instructions in the following table.
If it is still not possible to resolve the problem, contact customer service. Do not
repair the product yourself.
Problem
The product cannot be
switched on.
Strong odor during
vaporization.
No vaporization.
Water spills out or
leaks.
14
Solution
Make sure the power adapter is connected to the
base unit and a power outlet.
− Clean the water tank (see chapter "Cleaning").
− Always fi ll the water tank with fresh water.
Fill the water tank with sufficient amount of water.
− Make sure the water tank is not overfi lled.
− Make sure the water tank cap is tightened.
− Place the water tank properly on the base unit.
4 (see Fig. J).