Rear Panel - QP-Audio Habitat Serie Manual De Usuario

QP-AUDIO HABITAT SERIES H120

REAR PANEL

1
10
11
1.- AC fuse.
2.- Expansion ports ( AMP-IN/AMP-OUT/LINK-IN/LINK-OUT ).
3.- M.O.H (Music On Hold) output and level control.
4.- Pre-announce chime level control.
5.- Gain controls for variable input level.
6.- Phantom power and priority control switches.
7.- Signal input connectors.
8.- Remote microphone station input connector and output level control.
9.- Telephone paging input connector.
10.- Speaker outputs connector ( 4-ohm, selectable 25V, 70V and 100V ).
11.- AC power cable.
CAUTION: Before you begin, make sure your mixer-amplifier is disconnected from the
power source, with the power switch in the "OFF" position and all level controls turned
completely down (counterclockwise). You may stack mixer-amplifiers without using a
cabinet or you may place a single mixer-amplifier on a surface with 12-inches
(about 30cm) of air space around the unit for convection cooling.
When using an equipment rack, do not mount units directly on top of each other.
Allow 2U between units for convection cooling. The side walls of the rack should be
a minimum of 2-inches (about 5cm) away from the amplifier sides, and the back of
the rack should be a minimum of 4-inches (about 10cm) from the mixer-amplifier
rear panel.
5
2 3 4
9 8
7
6
15