Publicidad
Place Blue, or Red shim here.
Rock Facing should be facing out.
Piece Count = (3) A, (6) B, (3) X, (4) Y, (2) 6x10"
Corners, (2) 3 5/8x10" Cut Stones,
(2) 6x10"x1 1/2" Cut Stones, (2) Cast Stone Cor-
ner Mantles, (1) Cast Stone Center Mantle
Apply concrete adhesive and install wall stones
and cut stones according to the photo. Install the
3 piece mantel as shown making sure to center
the pieces on the headstones with equal over-
hang on the left and right sides.
Note: The mantel should fit tight against the
front of the pizza engine.
required on this layer.
Cambridge Pre-Packaged / Pre-Cut
MaytRx Wall Pizza Oven Kit
Layer 8:
The use of shims is
Capa 8:
Numero de Piezas = (3)A, (6) B, (3) X, (4) Y, (2)
esquinas 6x10"x 1 1/2", (2) 3 5/8x10" Piedras
Cortadas, (2) 6x10" Piedras Cortadas, (3) Pedazo
de Chimenea
Aplique el pegamento concreto e instale las pie-
dras de la pared y corte las piedras según el
cuadro abajo. Instale la chimenea de 3 pedazos
como se muestra que se cerciora de centrar los
pedazos en las lápidas mortuorias con la proyec-
ción igual en los lados izquierdos y derechos.
Nota: La chimenea debe caber firmemente contra
el frente del motor de la pizza.
21
2011
Place Blue, or Red shim here.
Rock Facing should be facing out.
Publicidad
