Oster BCSTFP0000 Manual De Instrucciones página 9

Warming
IMPORTANT:
• Parts and accessories are for use with this appliance
only. Parts, including the food container lid, are not to
be boiled or microwaved.
• Place the appliance on a flat and stable surface.
• Make sure the appliance and supply cord are out of
children's reach.
1. fill nutrient collector/measuring cup (17) with filtered
and distilled water to the recommended water level
(see table on page 13) and pour it into the water res-
ervoir (13). fill marks are located on the inside of the
base of the container.
WARNING: do not overfill water reservoir. the bottle
or food container may be heated too long and the
food may be too hot for feeding.
2. lock the water reservoir lid (14) into place on
the water reservoir (15) by twisting the double
arrow icon clockwise until the blend/warming
icon is aligned with the arrow
3. lock the warmer (24) into place over the motor drive
(16) by twisting the arrow on the warmer (24) from
unlocked to locked .
* Make sure the warmer steam entry (25) is fully
engaged with the water reservoir lid steam guide (16).
4. Place the bottle or food container in the center of the
warmer (24).
* Place food container lid (29) on container to
prevent food spills during warming.
5. Plug the power supply cord into an electrical outlet
and press the on / off button
* a 1-second beep and illuminated power light will
indicate the oster
6. Press the steam button
* a 1-second beep and illuminated steam light will
indicate that WaRMinG has begun.
WARNING: during WaRMinG, the warmer
releases steam through the interior vent holes in
the warmer holder. Keep clear of the steam during
Warming to avoid injury.
* WaRMinG is complete when a 3 second beep has
sounded and the steam light turns off. the oster
baby nutrition center is now in stand-by
mode and the heating element is off.
7. Press on/off button
* the power light turns off, indicating that the
oster baby nutrition center is off.
®
8. Remove the bottle or food container for feeding.
WARNING: bottle and food container are hot after the
WaRMinG cycle. allow sufficient time for the bottle or
food container to cool before handling or use oven
mitts to handle immediately.
* shake bottle or mix food thoroughly to ensure even
temperature.
* test the temperature of the food before feeding.
if food is not warm, then operate for another
WaRMinG cycle.
at the base.
(10).
baby nutrition center is on.
®
(11).
(10).
®
Nutrition Center
8
English