Craftsman 536.889252 Manual Del Usuario página 7

_hb ARNING: Always wear
safety glasses or eye shields
while assembling snow
thrower.
TOOLS REQUIRED FOR
ASSEMBLY
1 - Knife to cut carton
2 - 1/2 inch wrenches
(or adjustable wrenches)
2 - 9/16 inch wrenches
(or adjustable wrenches)
2 - 3/4 inch wrenches
(or adjustable wrenches)
1 - Pliers (to spread cotter pin)
1 - Screwdriver
1 - Measuring tape or ruler
/'-"-4
o
Figure 1
Figure 1 shows the snow thrower in the
shipping position.
Figure 2 shows the snow thrower com-
pletely assembled.
References to the right or left hand side of
the snow thrower are from the viewpoint
of the operator's position behind the unit.
_r Drive Lever
Shifter Lever
Traction
Drive Lever
Chute
Deflector
Height
Adjust
Skid
Figure 2
TO REMOVE SNOW THROWER FROM
1. Locate all parts packed separately 5.
and remove from the carton.
NOTE: Place fuel stabilizer in a safe
place until needed for storage.
2. Remove and discard the packing ma- 6.
terial from around the snow thrower.
3. Cut down all four corners of the carton 7.
and lay the panels flat.
4. For shipping purposes, the height ad-
just skids are attached to the pallet.
Remove the screw that secures each
height adjust skid to the pallet. See
Figure 2.
F-O41074L 7
CARTON
Roll snow thrower off the pallet by
pulling on the lower handle.
CAUTION: DO NOT back over con-
trol cables.
Remove all packing material from the
unit.
Cut ties securing the clutch control
cable to the lower handle and lay
cable back away from the motor
frame.