Zircon LaserVision 6.0 Manual De Instrucciones página 12

Using the Slope Mode (LaserVision 7.0 only)
The LaserVision 7.0 features three common angle presets: 1/8, 1/4 and 1 inch
per foot. These presets can be used in either direction. Once activated, the
LaserVision 7.0 uses the selected angle as its reference point until changed
(Table II). After pressing the SLOPE button, the angle and direction appear at
the bottom of the display.
• To get to the desired angle and direction, press the SLOPE button repeatedly
until the desired angle and direction are found (Figure 14 below).
NOTE: Unless intentionally changed, the LaserVision 7.0 stays in the same
preset slope the next time the unit is turned on.
Pre-set Slopes (Laservision 7.0 only)
Slope 1
1/8 in./ft.
STD
1/8"
1/8"
1/4"
Figure 14: Selecting a Slope
Memorizing an Angle
The LaserVision also has the ability to store and recall any desired angle.
• Press the SLOPE button(7.0) or the MEMORY button(6.0) repeatedly until AT
appears at the bottom of the LCD.
• Place and hold the LaserVision at the desired angle to be memorized. Ensure
that the unit is steady.
• Press and hold the ON/OFF button until the bars start moving up and down
(Figure 9, page 7) and a short audio tone sounds. Once the bars stop moving,
the new angle has been memorized. This angle remains in the LaserVision's
memory until another angle is saved and will be recalled when AT is again
selected.
NOTE: Unless the mode is purposely changed, the LaserVision automatically
returns to the AT mode the next time the LaserVision is turned on. Pressing the
mode switch once returns the LaserVision to the standard mode.
Slope 2
1/4 in./ft.
slope
slope
slope
slope
Slope 3
1 in./ft.
Table II
1/4"
1"
AT
Transfer)
slope
1"
slope
slope
slope
(Angle
12