Zircon LaserVision 6.0 Manual De Instrucciones página 9

• Place the level in the same location.
• Press and release the ON/OFF button once again and wait for the calibration
indicators to stop moving, the axis arrow to disappear, and the final audio tone to
sound. This axis is now calibrated.
• Rotate the level end for end and calibrate the other plumb direction by following the
same procedure. Both plumb axis arrows should now have disappeared.
Allen Wrenches
The LaserVision comes with two allen wrenches packed in the end cap opposite
the laser. They can be stored there. When replacing the batteries, use the larger
3/32" allen wrench to remove the two front screws that hold the level module in
place. When aligning the laser, use the smaller 5/64" allen wrench to turn the
calibration screw.
Calibrating the LaserVision's Laser
Although calibrated when leaving the factory, the LaserVision's laser can be eas-
ily recalibrated to the original factory specifications to ensure precision.
• In order to check or calibrate the laser module, place the LaserVision level on
a flat, stable surface with a target area located approximately 50 ft. (15 m)
away (Figure 12, page 10).
NOTE: The surface need not be level.
• Turn on the laser and mark the position of the center of the laser spot on the
remote target, see point 1 (P1).
• Turn the LaserVision over.
• Return to the target area and mark the new position of the center of the spot,
see P2. If the second mark is above the first, then the calibration screw (which
is the screw closest to the center, on the bottom of the LaserVision) should be
turned clockwise using the smaller 5/64" Allen wrench provided in the end
cap opposite the laser. If the second mark is below the first, then turn the
calibration screw counter-clockwise (Figure 13, page 11). Adjust the calibra-
tion screw until the laser spot is halfway between the two marks, see P3.
NOTE: Do not turn the screw closest to the end as it will disassemble the laser
unit and invali date your warranty.
• Return the LaserVision to the upright position and check the spot location.
The laser spot should match the midpoint. If it does not, redo the above steps
until there is no change when the level is turned over.
NOTE: Do not turn the screw closest to the laser end. This screw keeps the laser
module in place. If this screw is turned, your warranty will no longer be valid.
9